Ge Stackable Washer Dryer Lid Won T Lock

If the washer was stopped before the cycle was complete.

Ge stackable washer dryer lid won t lock.

Door lock motor and switch assembly the door lock secures the washer door shut during operation. The release is normally accessible from below the door lock or on some models from inside the soap dispenser housing. Here is how to replace it on a stackable washer dryer. I inspected it and looked inside and saw that.

Once the washer door is closed the washer can begin operating. If the washer fills but won t start the agitation cycle the lid lock switch could be defective. Ge appliances offers troubleshooting support for washers and dryers. If it opens you re all set.

If the door lock is defective the washer door will not latch properly. Find the information you are looking for in videos faqs tips and more. The pause can occur because of the following. Most washers will have a manual release to unlock the mechanism and allow you to open the door or lid.

If the door or lid won t open at the end of the cycle then the lock mechanism may be at fault. A power failure or if it was put in the test mode at the factory. Left and right arrows move across top level links and expand close menus in sub levels. Hi all you guys helped me before.

If your washer is not spinning it could be the lid switch lock. So at work we have a stacked ge washer dryer. If it still won t budge proceed to plan b. Ge appliances the site navigation utilizes arrow enter escape and space bar key commands.

The lid lock mechanisms on some washers are heat activated which means overriding them is as simple as letting them cool off. No water coming out nothing. Nothing in none of the stages. To find the correct replacement part.